Veritas micro-adjust wheel marking gauge

The micro-adjust wheel marking gauge draws on over 20 years of manufacturing experience, with subtle improvements across the board. The adjustment mechanism built into the stainless-steel rod allows you to set an approximate projection and then fine tune the cutter within a range of just over 6mm.

A fine pitch internal thread allows slow, careful adjustment and locking knobs keep the setting from shifting in use.

The hardened steel wheel cutter scribes perfectly at any point of its circumference, cutting neat marks even in cross grain.

The wheel’s single sided bevel also pulls the gauge face against the stock, helping to maintain accuracy. The cutting edge is at the extreme edge of the rod, allowing you to use the gauge for transferring dimensions such as tenon shoulder and mortice depth.

When not in use the cutter retracts into a countersunk hollow in the gauge face for protection